SRAM I-MOTION 3 Manual page 8

M A I N T E N A N C E A N D C A R E
R E M O V E A N D F I T R E A R W H E E L
F I T T I N G T H E R E A R
W H E E L
» Place the rear wheel into the rear
frame.
Slide one retaining washer
9
each (1) onto each axle end.
The serrations of the retaining
washer must bear against the
dropout of the frame.
Align the cable stop bracket (2)
10
parallel to the frame stay (3).
Mount the axle nuts (4) and
11
tighten them alternately with
a torque of 30 – 40 Nm (266 – 350
in.lbs.).
If applicable, mount the brake
12
lever (5) between the two
straps of the frame clamp (6).
The frame clamp must be
seated on the frame with no
play. Use only self-locking nuts!
Tightening torque: 2 – 3 Nm (18 –
27 in.lbs.).
8
9
10
11
12
6
5
i-MOTION 3 · June 2006
1
2
3
4