SRAM I-MOTION 3 Manual page 13

A S S E M B L Y
O F C O M P O N E N T S
Slide one retaining washer
20
each (6) onto each axle end.
The serrations of the retaining
washer must bear against the
dropout of the frame.
Align the cable stop bracket (7)
21
parallel to the frame stay (8).
Mount the axle nuts (9) and
22
tighten them alternately with
a torque of 30 – 40 Nm (266 – 350
in.lbs.).
If applicable, mount the brake
23
lever (10) between the two
straps of the frame clamp (11).
The frame clamp must be
seated on the frame without
play. Use only self-locking nuts!
Tightening torque: 2 – 3 Nm (18 –
27 in.lbs.).
i-MOTION 3 · June 2006
20
21
22
23
11
10
6
7
8
9
13
E