Nad Viso Dvd Receiver Setup - NAD VISO SPEAKERS Owner's Manual

not to over-tighten and damage the connectors.
E. NAD VISO DVD Receiver Setup
NAD VISO FIVE
If you're using an NAD VISO FIVE DVD Receiver connected to an NAD VISO
THIRTY and NAD VISO TWENTY, you must configure the Speaker Settings
to calibrate the frequency response of the system. The following steps will
guide you in configuring your NAD VISO FIVE with respect to NAD VISO
THIRTY and NAD VISO TWENTY speakers.
Ensure that your NAD VISO FIVE is unplugged when you connect the
speakers. It is also advisable to power-down or unplug all associated
components while making or breaking any signal or AC power connections.
Connect at least one of the NAD VISO FIVE Monitor Outputs (Component
Video, S-Video or Composite Video Monitor Out) to a corresponding video
input of a compatible TV/Monitor.
A. With NAD VISO THIRTY and NAD VISO TWENTY speakers connected to
the corresponding speaker terminals of your NAD VISO FIVE, connect the
supplied AC cord to NAD VISO FIVE's AC Mains input and then plug into
an AC outlet.
B. The Standby LED indicator embedded around the bezel of the POWER
button in the front panel will illuminate amber. Press the POWER button to
turn ON the NAD VISO FIVE. The Standby LED indicator will turn from
amber to blue. Turn ON also your TV/Monitor and set it to the
corresponding video input setting.
You may operate the NAD VISO FIVE from its front panel in combination with
the supplied HTR 7 remote control. Since the remote control will be the
primary controller for most cases, the following procedures are all made with
reference to the use of the appropriate HTR 7 button controls.
Speaker Settings
1. Using the HTR 7 remote control, press the [SETUP] button. Below On-
Screen-Display (OSD) will appear in your connected TV/Monitor.
Setup Menu
Audio Setup Menu
Video Setup Menu
OSC Language
Exit
8