Subwoofer Level - NAD VISO SPEAKERS Owner's Manual

3. Press [ENTER]. While at the "Front" menu item, use the [ ] button to
select the "Small" setting - this is the calibrated Speaker Setting when
using the NAD VISO TWENTY speakers.
4. Use the [ ] button to scroll down to the "Save & Exit" menu item. Press
[ENTER] to save the new settings and at the same time exit the Speaker
Settings menu. Press [SETUP] button to completely exit the Setup menu
OSD.
F. Subwoofer Level
When calibrated, the bass reproduced by the subwoofer is on the same
relative level as the signal reproduced by the full range speakers.
Always start your subwoofer volume adjustments from the calibrated
subwoofer reference level. The calibrated subwoofer reference level is
achieved when the volume switch on the VISO subwoofer is set to the 0dB
position (factory default) and subwoofer level is set to 0dB on the VISO
receiver. Use the [ ] or [ ] buttons on your receiver's remote control to adjust
the subwoofer level.
Another setting that achieves the calibrated subwoofer reference level is the
+10dB position on the VISO subwoofer and the -10dB subwoofer level on the
VISO receiver.
With the subwoofer volume set to 0dB, if by gradually increasing bass output
at the VISO receiver a point is reached at which the subwoofer starts audibly
Audio Setup Menu
Listening Mode
Input Settings
Speakers Settings
Channel Levels
Exit
Speaker Settings
Front
Subwoofer
Enhanced Bass
Do not Save & Exit
Save & Exit
13
Small
On
Off