Removing The Lower Handlebar Cover; Partial Removal Of The Upper Handlebar Cover - APRILIA SR 50 - 1998 Manual

1
3
2
4
9
REMOVING THE LOWER
HANDLEBAR COVER
Carefully read p. 39 (MAINTENANCE).
N Remove the cover support element, see
p. 50 (REMOVING THE COVER SUP-
PORT ELEMENT).
NOTE
Support the front part of the fairing
(1), to prevent it from accidentally falling
down.
N
Unscrew and remove the two screws (2).
CAUTION
Handle the plastic or painted components
with care and avoid scraping or damag-
ing them.
N Remove the front part of the fairing (1).
N Take the spacer (3).
N
Unscrew and remove the screw (4).
N
Rotate the handlebar completely right-
wards, unscrew and remove the screw (5)
(with shorter diameter) and the screws (6)
(7) and (8).
11
2
8
7
NOTE
Upon reassembly, fit the screws (5)
(with shorter diameter) in the relevant seats.
N Rotate the handlebar in central position,
withdraw the lower handlebar cover (9)
from the front and remove it.
PARTIAL REMOVAL OF THE
UPPER HANDLEBAR COVER
Carefully read p. 39 (MAINTENANCE).
N Remove the rear-view mirrors, see p. 53
(REMOVING THE REAR-VIEW MIR-
RORS).
N Remove the lower handlebar cover, see
beside (REMOVING THE LOWER HAN-
DLEBAR COVER).
N
Disconnect the two electric terminals
(10).
12
5
The upper handlebar cover (11) (complete
with switches, instruments and indica-
tors) remains connected with the speed-
ometer cable and with the electric cables,
which makes it impossible to remove it
completely.
Proceed with care in order to avoid dam-
aging the components.
N Paying attention to the two switch connec-
tions (12), lift the upper handlebar cover
and rotate it forwards, then rest it on the
front shield.
NOTE
Upon reassembly, when position-
ing the upper handlebar cover, pass the elec-
tric terminal cables (10) behind and under
the handlebar.
use and maintenance SR 50
10
CAUTION
51