Table of Contents
Advertisement
N
Lock at least one wheel, by pulling a
brake lever.
N
Position the shifting lever in neutral
(green warning light " " on).
N
Move the engine stop switch (9) to posi-
tion " ".
N
Make sure that the light switch (10) is in
position "• ".
N
Make sure that the dimmer switch
(11) is in position "
".
N
If the vehicle is started with cold engine,
rotate the cold start lever " " (12) down-
wards.
CAUTION
To avoid excessive consumption of the
battery, do not keep the start push but-
ton " " pressed for more than fifteen
seconds.
If the engine does not start in this lapse
of time, wait ten seconds and press the
start push button " " again.
44
use and maintenance SL mille
N
Press the start push button " " (13)
without accelerating and release it as
soon as the engine starts.
CAUTION
Avoid pressing the start push button
" " (13) when the engine is running,
since you may damage the starter.
If the engine oil pressure warning light
"
" (2) remains on, or if it comes on
during the normal operation of the en-
gine, this means that the oil pressure in
the circuit is insufficient. In this case,
stop the engine immediately and con-
tact an
Official Dealer.
N
Keep at least one brake lever pulled and
do not accelerate until you start.
CAUTION
Never leave abruptly with cold engine.
To reduce the emission of polluting
substances and the consumption of fu-
el, warm the engine up by proceeding at
low speed for the first miles.
N
Rotate the cold start lever " " (12) up-
wards after the engine has warmed up.
CAUTION
(),
If the writing "
" appears, on the left
display (multifunction) during the nor-
mal operation of the engine, this means
that the electronic unit has detected an
anomaly.
In many cases, the engine keeps run-
ning with reduced performance levels;
immediately contact an
Dealer.
Official
Advertisement
Table of Contents
