Figure 3-3 General: State; Table 3-3 General: State - ZyXEL Communications ZYWALL IDP 10 User Manual

ZyWALL IDP 10 User's Guide
LABEL
between 1 and 4094.
Apply Click this button to save your changes back to the ZyWALL.
Reset Click this button to begin configuring this screen afresh.
3.3.1 State
To change your ZyWALL's State settings, click GENERAL, then the State tab.
The following table describes the fields in this screen.
LABEL
Device Operation State Setup
Inline: The ZyWALL will both identify suspicious or malicious packets and perform the
action dictated by the rule for that type of intrusion (block, log, drop, send an alarm).
Monitor: Monitor means the ZyWALL will function as a traditional IDS (Intrusion
Detection System) by identifying suspicious or malicious packets and then sending alerts
Device Operation (only). Monitor state may be advisable when you first deploy the ZyWALL in your
State: network so valid traffic is not blocked ("false positives") nor invalid traffic wrongly allowed
(""false negatives"). When "false positives" and "false negatives" have been identified
and corrected, you should then change to Inline.
Bypass: All LAN and WAN traffic is allowed to pass through the ZyWALL without
inspection.
Apply Click this button to save your changes back to the ZyWALL.
Reset Click this button to begin configuring this screen afresh.
3-4
Table 3-2 General: VLAN
DESCRIPTION

Figure 3-3 General: State

Table 3-3 General: State

DESCRIPTION
General Settings