Time And Date; Figure 8-2 Debug Mode Reset Example - ZyXEL Communications ZYWALL IDP 10 User Manual

ZyWALL IDP 10 User's Guide
2. As the ZyWALL restarts you must enter debug mode before the login screen appears. Press
<ENTER> within 5 seconds of when the console screen displays "Press ENTER to enter Debug
Mode".
3. Type after the "debug"prompt. You will lose all your custom ZyWALL configurations
reset
including your user-defined rules. (If you type
erased too). The IP address of the ZyWALL will be "192.168.1.3" and the password will be
"1234".
4. Type to restart the ZyWALL and complete the reset. (This is also how you exit debug
reboot
mode.)
The following screen is an example of how you reset the ZyWALL to the factory defaults while in
debug mode.
IDS system kernel loader v1.0.0.0 2004/04/02 (ZyXEL)
Press ENTER to enter Debug Mode
Enter DEBUG Mode
.....
Loading Kernel Image <DBGBOOT>
...........................................
Checksum is valid.
Starting address is at 0x100000
Kernel image load completed.
Starting kernel...
DebugKernel Version 1.0.4 (2004/05/05)
DBG>
DBG>reset
Are you sure to reset all settings to manufacturing defaults? (y/n)y
Reset to defaults OK. Please reboot to apply new change.
DBG>reboot
8.3

Time and Date

To change your ZyWALL's time and date, click MAINTENANCE, then the Time and Date tab. The
screen appears as shown. Use this screen to configure the ZyWALL's time based on your local time
zone.
8.3.1 Pre-defined NTP Time Servers List
The ZyWALL uses the following pre-defined list of NTP timeservers if you do not specify a
timeserver or it cannot synchronize with the timeserver you specified.
8-2
reset all

Figure 8-2 Debug Mode Reset Example

, then all pre-defined rules will be
Maintenance Screens