F03. How To Configure A Nat - ZyXEL Communications ZYWALL 1050 Support Notes

Certainly, the related configuration like the Firewall ACL check must be set.
After the configuration is done, the LAN users are able to access the LAN server by typing
FQDN.

F03. How to configure a NAT?

Unlike ZyNOS ZyWALL, the NAT setting in ZyWALL 1050/ZyWALL USG 300 is in Policy
Route and port forwarding setting is Virtual Server as the configuration page is shown below.
Configure NAT setting in Configuration > Policy > Route
Configure port forwarding setting in Configuration > Virtual Server
In the policy route setting, there is the source network address translation (SNAT) setting is at
Address Translation area. Choose 'none' means to turn off the NAT feature for the policy route
rule accordingly. To choose "outgoing-interface" or other address objects you defined, it
means turn on the NAT feature and it will refer to the next-hop setting to execute routing.
All contents copyright (c) 2007 ZyXEL Communications Corporation.
ZyWALL 1050/ZyWALL USG 300 Support Notes
321