Dell POWEREDGE 2950 Hardware Owner's Manual page 77

4 Open the expansion-card guide latch and remove the filler bracket. See Figure 3-18.
5 Install the expansion card:
If the expansion card is full length, align its front edge with the front card guide. See Figure 3-18.
a
Position the expansion card so that the card-edge connector aligns with the expansion-card
b
connector on the expansion-card riser board.
Insert the card-edge connector firmly into the PCI card connector until the card is fully seated.
c
When the card is seated in the connector, close the expansion-card latch. See Figure 3-18.
d
Figure 3-18. Installing an Expansion Card
1
1 front card guide
4 expansion card
6 Connect any expansion-card cables for the new card.
See the documentation that came with the card for information about its cable connections.
7 Close the system. See "Closing the System" on page 55.
3
2
2 expansion-card connector
5 expansion-card guide latch
4
5
3 card-edge connector
Installing System Components
77