Using a T10 Torx driver, remove the two screws that secure the display module to the system
b
chassis.
Remove the display module from the chassis cutout.
c
Figure 3-35. Control Panel Removal
3
2
1
1
display module label
4
display module cable
7
control-panel circuit board
securing screws (3)
Installing the Control Panel Assembly
1 Insert the display module into the chassis cutout and secure with the two Torx screws.
2 Affix the display module label to the display module.
3 Install the control panel board in the system chassis and secure with the three Phillips screws. See
Figure 3-35.
106
Installing System Components
4
2
display module securing
screws (2)
5
control panel cable
5
6
7
3
display module
6
control panel circuit board