ZyXEL Communications NWA3000-N User Manual page 211

Table 84 Configuration > Log & Report > Log Setting > Edit (continued)
LABEL
Mail Server
Mail Subject
Send From
Send Log To
Send Alerts To
Sending Log
Day for Sending
Log
Time for Sending
Log
SMTP
Authentication
User Name
Password
Active Log and Alert
System log
E-mail Server 1
E-mail Server 2
NWA3000-N Series User's Guide
DESCRIPTION
Type the name or IP address of the outgoing SMTP server.
Type the subject line for the outgoing e-mail.
Type the e-mail address from which the outgoing e-mail is delivered. This
address is used in replies.
Type the e-mail address to which the outgoing e-mail is delivered.
Type the e-mail address to which alerts are delivered.
Select how often log information is e-mailed. Choices are: When Full,
Hourly and When Full, Daily and When Full, and Weekly and When
Full.
This field is available if the log is e-mailed weekly. Select the day of the
week the log is e-mailed.
This field is available if the log is e-mailed weekly or daily. Select the time of
day (hours and minutes) when the log is e-mailed. Use 24-hour notation.
Select this check box if it is necessary to provide a user name and password
to the SMTP server.
This box is effective when you select the SMTP Authentication check box.
Type the user name to provide to the SMTP server when the log is e-mailed.
This box is effective when you select the SMTP Authentication check box.
Type the password to provide to the SMTP server when the log is e-mailed.
Use the System Log drop-down list to change the log settings for all of the
log categories.
disable all logs (red X) - do not log any information for any category for
the system log or e-mail any logs to e-mail server 1 or 2.
enable normal logs (green check mark) - create log messages and alerts
for all categories for the system log. If e-mail server 1 or 2 also has normal
logs enabled, the device will e-mail logs to them.
enable normal logs and debug logs (yellow check mark) - create log
messages, alerts, and debugging information for all categories. The device
does not e-mail debugging information, even if this setting is selected.
Use the E-Mail Server 1 drop-down list to change the settings for e-
mailing logs to e-mail server 1 for all log categories.
Using the System Log drop-down list to disable all logs overrides your e-
mail server 1 settings.
enable normal logs (green check mark) - e-mail log messages for all
categories to e-mail server 1.
enable alert logs (red exclamation point) - e-mail alerts for all categories
to e-mail server 1.
Use the E-Mail Server 2 drop-down list to change the settings for e-
mailing logs to e-mail server 2 for all log categories.
Using the System Log drop-down list to disable all logs overrides your e-
mail server 2 settings.
enable normal logs (green check mark) - e-mail log messages for all
categories to e-mail server 2.
enable alert logs (red exclamation point) - e-mail alerts for all categories
to e-mail server 2.
Chapter 16 Log and Report
211