ZyXEL Communications NSA 210 - QUICK GUIDE V3.0 Quick Start Manual page 8

2. Place the NSA on a flat surface
with the bottom panel facing up.
This exposes the bottom panel
where the thumbscrew is located.
Loosen the thumbscrew using a
flat head screwdriver or a coin.
3. Bring the NSA to an upright
position and take off the front lid to
open the hard disk tray as shown
in the following:
4. Slide in the hard disk into the tray
until the hard disk is fitted snugly
inside the NSA.
5. Attach the front panel to cover the
hard disk tray. Place the NSA on a
flat surface with the bottom panel
facing up and tighten the screw.
8