ZyXEL Communications NSA 210 - QUICK GUIDE V3.0 Quick Start Manual page 10

3. Press the power button on the front of the NSA to
turn it on. Look at the front panel lights.
If no lights turn on, make sure the power cord is
not loose and that the power source is turned on.
• The power button light turns steady
blue.
• The SYS light turns steady green after
a successful startup (it takes about 50
seconds).
• The HDD lights come on if the NSA detects hard
drives in the disk bays.
• The rear panel LAN port has a light that turns on if
the Ethernet port is properly connected to your
network. It blinks while sending or receiving traffic.
To turn off the NSA, press the power button in and hold it
until you hear a beep. Then release the button.
Initializing the Hard Disk
Use the NAS Starter Utility to access the NSA. Follow
these steps:
10