ZyXEL Communications NBG-420N - QUICK GUIDE V3.60 Quick Start Manual page 11

If you cannot access the Internet when your computer is connected to one
of the NBG420N's LAN ports, check your connections. Then turn the
NBG420N off, wait for a few seconds and turn it back on. If this doesn't
work run the wizard again, making sure you type the information correctly.
Also, if you are using a new Internet account, contact your ISP to make
sure it is active. See Troubleshooting in the User's Guide for more
suggestions.
4 Set Up a Wireless Network
You can use Wi-Fi Protected Setup (WPS) to add wireless devices to your wireless
network. The other wireless devices must also support WPS.
If your wireless devices display the WPS logo as shown, go to
section 4.1 to use WPS to set up your wireless network.
If your wireless devices do not display the WPS logo, go to section
4.2 to manually set up a wireless network.
4.1 Set up Your Wireless Network with WPS
Follow these steps to set up your wireless network using WPS.
1 Place a WPS-enabled device within range of the NBG420N.
ENGLISH
11