Quality Of Service (Qos) Screen - ZyXEL Communications NBG-318S User Manual

Chapter 5 Wireless LAN
Table 30 Network > Wireless LAN > Advanced
LABEL
Enable Intra-
BSS Traffic
Output Power
802.11 Mode
Super G Mode
Apply
Reset

5.8 Quality of Service (QoS) Screen

The QoS screen allows you to automatically give a service (such as e-mail, VoIP or FTP) a
priority level.
Click Network > Wireless LAN > QoS. The following screen appears.
84
DESCRIPTION
A Basic Service Set (BSS) exists when all communications between wireless clients
or between a wireless client and a wired network client go through one access point
(AP).
Intra-BSS traffic is traffic between wireless clients in the BSS. When Intra-BSS is
enabled, wireless client A and B can access the wired network and communicate
with each other. When Intra-BSS is disabled, wireless client A and B can still access
the wired network but cannot communicate with each other.
Set the output power of the NBG-318S in this field. If there is a high density of APs
within an area, decrease the output power of the NBG-318S to reduce interference
with other APs.
Select 802.11b to allow only IEEE 802.11b compliant WLAN devices to associate
with the NBG-318S.
Select 802.11g to allow only IEEE 802.11g compliant WLAN devices to associate
with the NBG-318S.
Select 802.11b/g to allow either IEEE802.11b or IEEE802.11g compliant WLAN
devices to associate with the NBG-318S. The transmission rate of your NBG-318S
might be reduced.
Use this field to enable or disable the Super G function. Super G mode is available
only if you select 802.11g or 802.11b/g in the 802.11 Mode field.
Super G provides higher data transmission rates than 802.11g.
Select Disabled if your wireless clients do not support Super G.
Select Super G with Dynamic Turbo if some or all of your wireless clients support
Super G with Dynamic Turbo. Dynamic Turbo uses two channels bonded together to
achieve higher transmission rates than 802.11g or Super G without Dynamic Turbo.
Dynamic turbo is on only when all wireless devices on the network support it. The
wireless channel is automatically fixed at 6 if you select this mode.
Select Super G without Turbo if the wireless clients on your network support Super
G but do not support dynamic turbo.
Click Apply to save your changes back to the NBG-318S.
Click Reset to reload the previous configuration for this screen.
NBG-318S User's Guide