Inserting Batteries Into Remote Control - LENCO MDV-5 Instruction Manual

1. Introduction (cont)
Do not use solvents such as petrol based products, thinner, commercially
available cleaners or anti-static spray intended for vinyl LPs.
Disc installation precautions
Do not install more than 1 disc on disc tray
Do not place the disc on the tray up side down.
Do not try to close the disc tray when the disc is not inserted properly.

1.7 Inserting Batteries into Remote Control

Insert two AAA batteries into the remote control observing the polarity markings
inside the remote control compartment.
Notes:
Do not mix old and new batteries
Do not leave the remote in an extremely hot or humid place.
Do not expose the remote sensor to direct sunlight or lighting apparatuses.
Doing so may cause a malfunction.
If the remote control is not to be used for a long time, remove the batteries to
avoid the possible damage from battery leakage and corrosion.
4