Radio Operation - LENCO MC-140 Instruction Manual

Clock adjusting
1. In standby mode the LCD display will show --:-- flashing. Press and hold the C-ADJ/MEMORY
button for about 3 seconds. The display will show the 24 hours or the 12 hours version. Press CD
SKIP FORWARD/TUNING UP button to choose for the 12 or 24 hour version. Press
the C-ADJ/MEMORY button to confirm.
2. Enter the correct hour with the CD SKIP FORWARD/TUNING UP button, press the MEMORY
button to confirm. Enter the correct minutes with the CD SKIP FORWARD/TUNING UP button,
press the C-ADJ/MEMORY button to confirm.
To adjust volume
Press and/or hold the VOLUME UP/DOWN CONTROL to increase or decrease the volume.
Press the MUTE button on the remote control to turn off the sound. Press this button again to turn the
volume back on.
Built-in Different Equalizer System
This unit has a built-in equalizer system, Press preset EQ button on the main unit while playing to select
different music style (sound tone): PASS, CLASSIC, ROCK, POP and JAZZ.
HEADPHONE JACK
For private listening, insert a 3.5mm headphone (not included) into the HEADPHONE JACK. The
speaker output is automatically cut off.
CAUTION: LISTENING AT A HIGH VOLUME OVER A LONG PERIOD OF TIME COULD
DAMAGE USERS EARS.

RADIO OPERATION

TUNING IN RADIO STATIONS
1. Press the FUNCTION switch to select the RADIO mode, the display will show TUNER .
2. Press the BAND switch to select the desired wave band: AM (MW)/FM ST.
3. Tune to desired station by pressing the CD SKIP BACK/FORWARD & RADIO TUNING
UP/DOWN CONTROL, the display will show the band frequency. Example: FM 97.10 MHz
4. Adjust the VOLUME CONTROL to the to desired volume level.
5. Extend the ANTENNA WIRE to its full length if you are listening to FM broadcasting. Gently move
the wire back and forth to get the best reception when you are listening to AM program, or place the
unit in an open location.
6. When you are receiving FM stereo program, the display will show
MONO mode by pressing the FIND/ST/ESP button once, the display will show MONO , press the
FIND/ST/ESP button again, the display shows STEREO and get back to STEREO mode.
7. To turn off the radio, press the FUNCTION switch to enter CD, TAPE or CARD-USB operation, or
switch off the unit by pressing POWER ON/OFF button (the display will say GOOD BYE to you).
RADIO AUTO SCAN (SEARCH)
Press and hold the CD SKIP BACK/FORWARD & RADIO TUNING UP/DOWN CONTROL for 1 or 2
seconds and release. The unit will auto scan until having found a strong signal program. Press and hold
again to search other stations.
RADIO STATION MEMORY OPERATION
You can pre-store 40 (AM and FM) radio stations in the memory for your preference. With this
memory-option you can listen to your desired station directly and quickly, so you don't need to tune and
search for the stations again.
( ST ) . You can also set it to
( )
4