Digital A/V Connections; Use The Component Jacks To Connect A Dvd Player Or Other Digital Equipment; Connecting Digital Audio Output To A Multi-Channel Receiver - Sanyo DP42545 Owner's Manual

USE THE COMPONENT JACKS TO CONNECT A DVD PLAYER
OR OTHER DIGITAL EQUIPMENT
Switch off TV and external equipment before connecting
cables. ( Cables are not supplied. ) Follow these steps to
easily connect your STB or DVD to this Plasma TV.
1 Connect a DVD Player's (or other digital equipment's)
Component Video Out to the TV's Component Video
Input jacks.
2 Connect a DVD Player's (or other digital equipment's)
Audio Out to the TV's Component L/R Audio Input jacks.
3 Press the POWER key to turn on the Plasma TV. Turn
on external equipment.
4 Press the INPUT key to select the Input source
(Compo 2 or Compo 3).
NOTE: "No Signal" will appear on the screen for five seconds
when no signal or an unacceptable video format signal
is detected at the Compo 2 or Compo 3 inputs.
Remote Control
INPUT
POWER
1 1 1 2 2 3 3
4
4 4 5 5 6 6

CONNECTING DIGITAL AUDIO OUTPUT TO A MULTI-CHANNEL RECEIVER

Dolby ® Digital Audio provides 5.1 channels of surround
sound (five full-range channels [5] and one low-frequency
effect channel [.1]). A fiber optics cable is used to carry
the 5.1 surround sound (for low-noise signal transfer).
1 Using a Fiber Optics cable, connect the TV's Digital
Audio Output to the Digital Audio Input of a Multi-
Channel Receiver. (Fiber optics cable is not supplied.)
2 Press the POWER key to turn on the TV, then turn on
the external equipment.
NOTES: When making the connection, do not pinch or kink the
fiber optics cable.
Red light visible at the Digital Audio Output does not
necessarily indicate that Dolby 5.1 audio is available.
Digital audio is made up of light pulses that the human
eye cannot detect. Dolby 5.1 audio is available at the
Digital Audio Output only when received as part of a
Digital antenna signal.

DIGITAL A/V CONNECTIONS

What you will need
for connections:
Component Video Cable – 1
3
Audio Cable – 1
COMPONENT VIDEO OUT
Y P
B
VIDEO OUT SELECT
S
OPT.
COPONENT
S-VIDEO OUT R L
DIGITAL
OUT AUDIO OUT VIDEO OUT
VIDEO 1
AUDIO
OUTPUT
S-VIDEO
V
L L
(MONO)
AUDIO
R R
TV Back Component Jacks
I
Compo 2 and Compo 3 jacks are identical. Compatible
equipment can be connected to either set of jacks,
such as, a DVD player connected to Compo 3 and a
Satellite Receiver connected to Compo 2.
I
Press the INPUT key after connecting the cables to
select the Component 2 or Component 3 input signal.
There is NO need to tune to a blank channel.
Multi-Channel
Receiver
1
Optical
Digital Cable
DVD Player
(or other Digital
Device, such as,
P
R
a Digital Satellite
Receiver, or
Digital Cable Box)
COMPO 2 COMPO 3
Y Y
RESET
Pb Pb
Pr Pr
SERVICE
L L
R R
Back View of
Plasma TV
DIGITAL DIGITAL
DIGITAL DIGITAL
AUDIO AUDIO
ANTENNA IN ANTENNA IN
OUTPUT OUTPUT
1
2
11