Presetting Stations; Tape Playback; Basic Operations - Aiwa DINA Z-A60 Operating Instructions Manual

PRESETTING STATIONS

TUNER
BAND
c PRESET
s CLEAR
a SET
f,g
MULTI
JOG
TUNER
PRESET
The unit can store a total of 32 preset stations for all bands.
When a station is stored, a preset number is assigned to the
station. Use the preset number to tune in to a preset station
directly.
1 Press TUNER/BAND to select a band, and tune in
to a station with f f f DOWN or g f
f
2 Press a a SET to store the station. a a
a
A preset number beginning from 1 in consecutive order for
each band is assigned to a preset station.
Frequency
3 Repeat steps 1 and 2.
No more stations will be stored if a total of 32 preset stations
for all the bands have already been stored.
NOTE
"FULL" is displayed if you attempt to store more than 32 preset
stations.
PRESET NUMBER TUNING
Use the remote control to select the preset number directly.
1 Press BAND while pressing SHIFT to select a
band.
2 Press numbered buttons 0-9 and +10 to select a
preset number.
Example:
To select preset number 20, press +10, +10 and 0.
To select preset number 15, press +10 and 5.
Selecting a preset number on the main unit
Press TUNER/BAND to select a band. Press TUNER PRESET
repeatedly until the preset number flashes (preset tuning mode),
and turn MULTI JOG. The preset numbers are selected in
sequence as you turn MULTI JOG.
• cPRESET is also available to select the preset number. Each
time the button is pressed, the next highest number is selected.
To clear a preset station
Select the preset number of the station to be cleared with the
numbered buttons. Then, press sCLEAR, and press aSET
within 4 seconds.
The preset numbers of all other stations in the band with higher
numbers are decreased by one.

TAPE PLAYBACK

0-9,
+10
BAND
SHIFT
c
f,g
s
a
This unit is designed for optimal playback of Type I (normal) tapes.
1 Press TAPE/DECK 1/2, then press zPUSH EJECT
g g UP. g
g
Insert a tape with the exposed side down. Push the cassette
Preset number
holder to close.
2 Press c to start play.
To select a playing deck
When tapes are loaded in both decks, press TAPE/DECK 1/2
first to select a deck.
The selected deck number is displayed.
To stop play, press s
To pause play (Deck 2 only), press a
again.
To fast forward or rewind, press f
Then press s
To start play when the power is off (Direct Play Function)
Press TAPE/DECK 1/2. The power is turned on and play of the
inserted tape begins.
To set the tape counter to "0000".
Press s CLEAR in stop mode.
The counter is also set to "0000" when the cassette holder is
opened.
When tapes are loaded in both decks
After playback on deck 1 finishes, the tape in the deck 2 will start
to play without interruption and will stop at the end of the tape.
(Continuous play)

BASIC OPERATIONS

s
a
f,g
z PUSH
EJECT
DECK 1
to open the cassette holder.
Only the side facing out from the unit can be played back.
Playing deck number
s s s .
s
s s s s to stop the tape.
2
1
z PUSH
EJECT
DECK 2
The tape counter indicates
the tape running length.
a . To resume play, press a a
a
f f f f or g g . g g g
9
ENGLISH
En