Table of Contents
Advertisement
PRESETTING STATIONS
The unit can store a total of 32 preset stations. When a station
is stored, a preset number is assigned to the station.
Use the
preset number to tune in to a preset station directly.
1 Press the TUNER/BAND bution to select a band,
and press the ké< DOWN
or >>I UP button to
tune in to a station.
2 Press the I SET button to store the station.
A station is assigned a preset number, beginning from 1 in
consecutive order for each band.
Frequency
Preset number
3 Repeat steps 1 and 2.
Each band can only store a maximum of 20 preset stations.
However, the next station will not be stored if a total of 32 preset
stations have already been stored for all the bands.
PRESET NUMBER TUNING
Use the remote control to select the preset number directly.
71 Press the BAND button while pressing the SHIFT
button to select a band.
2 Press the numeric
buttons to select a preset
number.
Example:
To select preset number 20, press the +10, +10 and 0 buttons.
To select preset number 15, press the +10 and 5 buttons.
Selecting a preset number on the main unit
Press the TUNER/BAND
button to select a band. Then, press
the B PRESET button repeatedly.
Each time the button is pressed, the next higher number is
selected.
To clear a preset station
Select the preset number of the station to be cleared. Then, press
the I CLEAR button, and press the If SET button within 4
seconds.
The preset numbers of all other stations in the band with higher
numbers are also decreased by one.
To change the MW tuning interval
The default setting of the MW tuning interval is 9 kKHz/step. If you
use this unit in an area where the frequency allocation system is
10 kHz/step, change the tuning interval.
With the unit turned on, press the POWER button while pressing
the TUNER/BAND button.
To reset the interval, repeat this procedure.
When the MW tuning interval is changed, all preset stations (see
"PRESETTING
STATIONS') are cleared.
The preset stations
'have to be set again.
8
Advertisement
Table of Contents
