Table of Contents
Advertisement
Applying echo/reverb (FX)
As effects that process the output signal, the M-10DX provides two types of echo and five types of reverb.
You can edit the parameters of the echo/reverb effect to your needs and taste.
Use the AUX/FX knobs to adjust the depth of echo/reverb for each input (p. 12).
The edited settings are remembered even when the power is off.
Editing the effect settings
fig.FX-01
1.
Press the [FX] button so it's lit, turning the effect
on.
The FX screen will appear.
* If a different screen is displayed even though the [FX] button is lit,
you can press the [FX] button to access the echo/reverb screen.
fig.FX-02
If you press the [FX] button when the FX screen is already
displayed, the effect will be turned off and the button's light
will go out.
Selecting the effect type
fig.FX-01
2.
Use the CURSOR [BWD] [FWD] buttons to move
the cursor to the effect type.
3.
Use the VALUE [-] [+] buttons to select the effect
type.
Editing the parameters
fig.FX-03
4.
Use the CURSOR [BWD] [FWD] buttons to move
the cursor to the parameter you want to edit.
5.
Use the VALUE [-] [+] buttons to edit the value.
If you press the [+] button while holding down the [-] button, or press the [-] button while holding down the
[+] button, the value will change more rapidly, allowing you to edit the value more efficiently.
If the [FX] button is lit, you can hold down the [DISPLAY] button and press the [FX] button to turn the effect
off at any time.
Advanced use
27
Advertisement
Table of Contents
