Table of Contents
Advertisement
This is convenient when you want to check the current AUX
level of each channel.
fig.02-AUX2
* Press the DISPLAY button to return to the level meter screen.
7. PAN Knobs
Allow you to localize a mono input signal between L and R.
The signal will be located in the center when a knob is in the
(
) position.
* If the AUX/FX button is lit, this knob operates as the AUX/FX
knob to adjust the level of the signal sent from each channel to the
AUX SEND bus.
8. BAL Knobs
Adjust the volume balance of a stereo input signal (channels
3–6). The left and right channels will be at the same volume
when a knob is in the (
* If the AUX/FX button is lit, this knob operates as the AUX/FX
knob to adjust the level of the signal sent from each channel to the
AUX SEND bus.
9. SEL Buttons
If you press one of these buttons (the button will light), the
parameters of the selected channel will appear in the display
as the "parameter screen."
When calling up a scene (p. 36), this is a convenient way to
check the settings of each channel.
This button can be pressed at any time to toggle between the
"parameter screen" and "equalizer screen."
fig.02-SEL
Parameter screen
Equalizer screen
* Press the DISPLAY button to return to the level meter screen.
) position.
Names of things and what they do
10. Channel LEVEL Knobs
Adjust the levels of the signals input to the channels.
* In order to reduce the amount of noise in your mix, channels
you're not using should be set to the minimum level.
11. MAIN MIX LEVEL Knob
Adjusts the level of the signal that is output from MAIN OUT
jacks.
12. ROOM ACOUSTIC Button
The output from the M-10DX's MAIN OUT jacks or
CONTROL ROOM jacks can be automatically adjusted to
optimize the frequency response for your acoustical
environment.
➝ "Adjusting the output signal appropriately for your
environment (Room Acoustic Control)" (p. 29)
13. FINALIZE Button
Press this when you want to edit the Finalize settings. When
you press the button it will light, and the Finalize screen will
appear.
➝ "Creating a well-balanced sound (Finalize)" (p. 34)
14. FX Button
If you press this button so it's lit, FX (echo, reverb) will be
turned on, and the signal processed by the effect will be sent
to the MAIN bus.
➝ "Applying echo/reverb (FX)" (p. 27)
15. POWER Switch
Turns the power on/off. When the power is on, this button
will light.
Hold down this switch for at least one second.
16. PHONES/CTRL ROOM Knob
Adjusts the volume of the signal that is output to the PHONES
jack and the CONTROL ROOM jacks.
17. Display
This graphically shows the input level of all channels and
output level of MAIN OUT jacks, or displays parameters and
their values.
BUS
A "bus" is a signal route to which multiple signals within
the mixer are combined.
There are two buses—MAIN (L, R) and AUX SEND—and
the signals combined to each bus are sent to the
corresponding output route.
13
Advertisement
Table of Contents
