Setting Example Of The Router - Panasonic WV-NS202A Network Operating Instructions

Setting example of the router

This camera transmits MPEG-4 images using UDP protocol.
To display MPEG-4 images using a router, it is necessary to configure the settings (UDP port setup) of both the
camera and the router as below.
Step 1
Configure "MPEG-4 setup" of the camera as follows.
q Transmission type: Unicast port (MANUAL)
w Unicast port1 (Image): 32004
e Unicast port2 (Audio): 33004
Step 2
Configure the router q to which the camera is connected as follows.
Address mapping table
Group LAN IP address
192.168.0.10
Camera 192.168.0.10
192.168.0.10
Step 3
Configure the router w to which the PC is connected as follows.
Address mapping table*
Group WAN IP address
WAN IP address of the router
PC
WAN IP address of the router
IP address: 192.168.0.10
LOC K
OP EN
* The address mapping table is the example for when using a typical router.
Depending on the manufacturer of the router, it may be described as "static IP masquerade".
LAN port
TCP port: 80 <--->
UDP port: 32004 <--->
UDP port: 33004 <--->
Protocol
UDP port: 33004
UDP port: 32004
Router q
WAN IP address
WAN IP address of the router
WAN IP address of the router
WAN IP address of the router
LAN IP address
<---> 192.168.0.101
<---> 192.168.0.101
Internet
Router w
Protocol
HTTP (TCP port: 80)
UDP port: 32004
UDP port: 33004
LAN port
UDP port: 33004
UDP port: 32004
PC
IP address: 192.168.0.101
89