Troubleshooting - Panasonic WV-NS202A Network Operating Instructions

Troubleshooting

Before asking for repairs, check the symptoms on the following table.
Contact your dealer if a problem cannot be solved even after checking and trying the solution or if the problem is not
described below.
Symptom
Cannot access from the
browser.
Cause/solution
• Is the LAN cable (category 5) firmly connected to the
network connector on the rear of the camera?
• Is the link LED right by the network connector lit?
When it is not lit, connection to a LAN may not be
established or a network may be not working correct-
ly. Check if the cables have any contact failure or if
the wiring is correct or not.
• Is the power of the camera on?
Check if the power of the camera is turned on.
• Are the set IP addresses valid?
• Are you accessing the wrong IP address?
Check the connection as follows:
With the Windows command prompt,
> ping "IP address of the camera"
When the WV-NS202A replies, the camera is func-
tioning normally.
If not, proceed either of the following.
• Restart the camera and change the IP address by
using the Panasonic IP setup software within 20
minutes after the restart.
• Restart the camera while holding the [INITIAL
SET] button on the rear of the camera. The cam-
era will be initialized and the IP address will return
to the default setting "192.168.0.10".
After the camera is initialized, access the camera
and set the IP address again. (When the camera
is initialized, all the settings of the camera previ-
ously configured on the setup menus will be initial-
ized.)
Reference
pages
Installation
Guide
Installation
Guide
Installation
Guide
67
–
78
81