Connecting To Other Equipment; Connecting To A Pc - Panasonic Lumix DMC-FS15 Operating Instructions Manual

Connecting to other equipment

Connecting to other equipment

Connecting to a PC

You can acquire recorded pictures to a PC by connecting the camera and the PC.
• You can easily print out or e-mail the pictures you have imported. Use of the
"PHOTOfunSTUDIO" bundled software on the CD-ROM (supplied) is a convenient way of
doing this.
• Read the separate operating instructions for the supplied software for more information about
the software in the CD-ROM (supplied) and how to install it.
Preparations:
Turn on the camera and the PC.
Remove the card before using the pictures in the built-in memory.
A USB connection cable (supplied)
• Check the directions of the connectors, and plug them straight in or unplug them straight out.
(Otherwise the connectors may be bent out of shape which will cause a malfunction.)
B Align the marks, and insert.
• Use a battery with sufficient battery power or the AC adaptor (DMW-AC5PP; optional) and DC
coupler (DMW-DCC4; optional). If the remaining battery power becomes low while the camera
and the PC are communicating, the status indicator blinks and the alarm beeps.
Refer to "Disconnecting the USB connection cable safely" (P83) before disconnecting the USB
connection cable. Otherwise, data may be destroyed.
Connect the camera to a PC via the USB connection cable A
(supplied).
• Do not use any other USB connection cables except the supplied one.
Use of cables other than the supplied USB connection cable may cause a malfunction.
Press 3/4 to select [PC], and then press [MENU/
SET].
• If [USB MODE] (P24) is set to [PC] in the [SETUP] menu in
advance, the camera will be automatically connected to the PC
without displaying the [USB MODE] selection screen. Since there is
no need to set this each time you connect to the PC, it is convenient.
• When the camera has been connected to the PC with [USB MODE]
set to [PictBridge(PTP)], a message may appear on the PC's
screen. Select [Cancel] to close the screen, and disconnect the
camera from the PC. Then set [USB MODE] to [PC] again.
82
VQT1W26
AV OUT
DIGITAL
USB MODE
PLEASE SELECT
THE USB MODE
PictBridge(PTP)
PC
SELECT SET