Recording Setup Screen - Panasonic AG-HPX250 Operating Instructions Manual

RECORDING SETUP screen

Item
REC FUNCTION Sets special recording modes.
NORMAL:
The special recording modes are not used.
INTERVAL:
Sets interval recording.
ONE SHOT:
Sets one-shot recording.
LOOP:
Sets loop recording.
"Using special recording modes" (Page 43)
• This function is always set to NORMAL when the power
is turned on.
ONE SHOT TIME Sets the duration for one-shot recording.
1frm, 2frm, 4frm, 8frm, 16frm, 1s
"One-shot recording (ONE SHOT REC)" (Page 45)
INTERVAL TIME Sets the time interval of interval recording.
2frm, 4frm, 8frm, 16frm, 1s, 2s, 5s, 10s, 30s, 1min,
5min, 10min
"Interval recording (INTERVAL REC)" (Page 44)
START DELAY This delays the start of interval and one-shot recording by
about 1 second.
ON, OFF
PREREC MODE Sets PRE REC.
ON, OFF
"Pre-recording (PRE REC)" (Page 44)
TC MODE Sets count correction when using the internal time code
generator.
DF:
Drop frame time code
NDF:
Non drop frame time code
"Setting the time code" (Page 66)
TCG Sets the mode in which you advance the time code.
FREE RUN:
The time code is advanced regardless of the operation
mode.
• In native recording in VFR mode, if the number of
frames differs for shooting and recording, the time code
changes to REC RUN.
REC RUN:
The time code is advanced only when recording.
___indicates the factory setting.
Setting Notes
• Not available in the following
conditions.
· W hen REC SIGNAL is set to
1394
· W hen REC FORMAT is set to
native recording.
· W hen SYSTEM MODE is set
to 1080- 59.94i or 480-59.94i;
and CAMERA MODE is set to
24P or 24PA.
· W hen compiling to a clip in
one-clip recording mode.
· W hen VFR is set to ON.
• Can only be set when REC
FUNCTION is ONE SHOT.
• Can only be set when REC
FUNCTION is INTERVAL.
• Can only be set when REC
FUNCTION is INTERVAL or
ONE SHOT.
• Not available in the following
conditions.
· W hen REC SIGNAL is set to
1394.
· W hen VFR is set to ON.
· W hen REC FORMAT is set to
native recording.
· W hen SYSTEM MODE is set
to 1080-59.94i or 480-59.94i;
and CAMERA MODE is set to
24P or 24PA.
· W hen REC FUNCTION is
set to something other than
NORMAL.
• Not displayed in 1080-50i, 720-
50P, 576-50i.
• Not available when operates
24P, 24PA or 24PN mode.
Counts NDF time code in 24P,
24PA or 24PN mode.
141