Terminal Panel Features - NEC NP1000 User Manual

Terminal Panel Features

4
5
6
The actual appearance of the terminal panel may differ slightly from that shown in the drawing, but this does not affect
the projector's performance.
1. COMPUTER 1 IN/Component Connector (Mini D-
Sub 15 Pin) (→page 13, 15)
AUDIO IN (Stereo Mini Jack) (→page 13, 14, 16)
2. COMPUTER 2 IN/Component (R/cr, G/V, B/cb, H,
V) Connectors (BNC x 5) (→page 13)
AUDIO IN (Stereo Mini Jack) (→page 13)
3. COMPUTER 3 IN Connector (DVI-D 24 Pin) (HDCP
compatible) (→page 14)
AUDIO IN (Stereo Mini Jack) (→page 14)
4. COMPONENT IN (Y, Cb/Pb, Cr/Pr) Connectors
(RCA) (→page 17)
AUDIO L/MONO, R (RCA) (→page 17)
5. S-VIDEO IN Connector (Mini DIN 4 Pin) (→page
18)
6. VIDEO IN Connector (RCA) (→page 18)
7. VIDEO/S-VIDEO AUDIO L/MONO, R (RCA) (→page
18)
8. MONITOR OUT Connector (Mini D-Sub 15 Pin)
(→page 16)
15 14 13 12
7 8 9
9. AUDIO OUT (Stereo Mini Jack) (→page 16)
10. PC CONTROL Port (D-Sub 9 Pin) (→page 127, 128)
11. Remote Jack (Stereo Mini Jack) (→page 11)
NOTE: Connecting the remote cable to the REMOTE mini jack on
the terminal panel will make the wireless operation unavailable.
12. USB Port (Type A) (→page 38, 59)
13. LAN Port (RJ-45) (→page 19, 89)
14. PC CARD Eject Button (→page 22)
15. PC CARD Slot (→page 21)
NOTE: A dummy card is inserted into each slot at the time of
shipment. First remove the dummy cards before use.
8
3
1 2 10
Use this port to connect your PC or control system to
control your projector via a serial cable. This enables
you to control the projector using serial communica-
tion protocol. A commercially available RS232C cross
cable is required to use this port. You can also control
the projector by using PC Control Utility 3.0 contained
on the supplied User Supportware 3 CD-ROM. To do
so you must first have PC Control Utility 3.0 installed
on your PC. If you are writing your own program, typi-
cal PC control codes are on page 127.
1. Introduction
11