Indicator Messages; Appendix; Troubleshooting - NEC NP1000 User Manual

9. Appendix

Troubleshooting

This section helps you resolve problems you may encounter while setting up or using the projector.

Indicator Messages

Power Indicator
Indicator Condition
Off
Blinking light Green
Orange
Steady light Green
Orange
Status Indicator
Indicator Condition
Off
Blinking light Red
Green
Orange
Steady light Orange
Green
Lamp Indicator
Indicator Condition
Off
Red
Blinking light
Steady light Red
Green
The main power is off
0.5 sec On, The projector is getting ready to turn on.
0.5 sec Off
2.5 sec On, Off Timer or Program Timer (Off Time) is
0.5 sec Off activated.
0.5 sec On, The projector is cooling down.
0.5 sec Off
2.5 sec On, Program Timer (On Time) is activated.
0.5 sec Off
The projector is turned on.
The projector is in Standby.
Normal
1 cycle (0.5 sec On, Lamp cover error
2.5 sec Off)
2 cycle (0.5 sec On, Temperature error
0.5 sec Of)
3 cycle (0.5 sec On, Power error
0.5 sec Off)
4 cycle (0.5 sec On, Fan error
0.5 sec Off)
6 cycle (0.5 sec On, Lamp error
0.5 sec Off)
Re-firing the lamp
1 cycle (0.5 sec On, Network conflict
2.5 sec Off)
Control Panel Lock is on
The projector is in Standby.
Normal
Lamp has reached its end of life. Lamp
replacement message will be displayed.
Lamp has been used beyond its limit. The
projector will not turn on until the lamp is
replaced.
Lamp is in Eco mode
117
Projector Condition
Projector Condition
Projector Condition
Note
–
Wait for a moment.
–
Wait for a moment.
–
–
–
Note
–
Reattach the lamp cover correctly.
(→ page 112)
The projector is overheated. Move
the projector to a cooler location.
Power unit will not work correctly.
Fans will not work correctly.
Lamp fails to light. Wait a full
minute and then turn on again.
The projector is re-firing.
Both the built-in LAN and the wire-
less LAN cannot be connected to
the same network at the same time.
To use both built-in LAN and wire-
less LAN at the same time, connect
them to different networks.
(→ page 90, 91)
You have pressed cabinet button
when Control Panel Lock is on.
(→ page 82)
–
Note
–
Replace the lamp.
(→ page 110)
Replace the lamp.
(→ page 110)
–