Changing Eco Mode/Checking Energy-Saving Effect Using Eco Mode [Eco Mode]; Changing Eco Mode/Checking Energy-Saving Effect Using Eco Mode - NEC NP-P350W User Manual

2. Press the  button.
The area of the magnified image will be moved
3. Press the D-ZOOM (−) button.
Each time the D-ZOOM (−) button is pressed, the image is reduced.
NOTE:
• The image will be enlarged or reduced at the center of the screen.
• Displaying the menu will cancel the current magnification.
 Changing Eco Mode/Checking Energy-Saving Effect Using Eco
Mode [ECO MODE]
The ECO MODE (ECO1 and ECO2) increases lamp life, while lowering power consumption and cutting down on CO
emissions.
Four brightness modes of the lamp can be selected: [OFF], [AUTO ECO], [ECO1] and [ECO2] modes.
[ECO MODE]
[OFF]
[AUTO ECO]
[ECO1]
[ECO2] (P350X
only)
To turn on the [ECO MODE], do the following:
1. Press the ECO Button on the remote control to display [ECO MODE] screen.
2. Press the ECO button again to select a mode you wish.
• Each time the ECO button is pressed, the choices will be changed:
OFF → AUTO ECO → ECO1 (→ ECO2) → OFF
• When the projector is in ECO mode, the LAMP indicator will light green.
TIP:
• The leaf symbol at the bottom of the menu shows the current selection of ECO mode.
Description
This is the default setting (100% Brightness).
Lamp power consumption will be changed between
[OFF] and [ECO1] automatically according to picture
level
NOTE: A bright gradation may be less visible depending
on the image.
Low lamp power consumption (approx. 75% Bright-
ness).
Lower lamp power consumption than [ECO1] mode
(approx. 60% Brightness)
28
3. Convenient Features
Status of LAMP indicator
Off
Steady Green
light
2