External Dvi Device With Dvi-Hd - Mitsubishi WL-82913 Connections And Maintenance

Mitsubishi wl-82913: owners guide

Table of Contents

Connecting MonitorLink™ with MonitorLink Control or DVI-HD

MonitorLink and MonitorLink Control

Figure 14

1. Connect a MonitorLink cable from the Mitsubishi Receiver/Controller back panel to the TV back panel.

2. Connect the L (left) and R (right) audio cables from the Mitsubishi Receiver/Controller to AUDIO LEFT and AUDIO

RIGHT on the MonitorLink section of the TV back panel.

3. Connect the MonitorLink Control cable from the Mitsubishi Receiver/Controller back panel to the TV back panel.

External DVI Device with DVI-HD

Figure 14

1. Connect a DVI cable from the DVI output of the external DVI type device to the MonitorLink/DVI-HD input on the

back of the TV.

2. Connect the L (left) and R (right) audio cables from the external DVI device to AUDIO LEFT and AUDIO RIGHT on

the MonitorLink section of the TV back panel.

NOTE: When used as a DVI Input, the MonitorLink input is compliant with HDCP and the EIA-861 standards for

standard, extended and high definition video; however, this input is not intended for use with personal computers

or devices outputting video signals with computer resolution.

��

Figure 14. Connecting MonitorLink/DVI

CAUTION: To ensure continued FCC compliance, the user must use a shielded video interface

cable with bonded ferrite cores when using the PC input, and with bonded ferrite cores at

both ends when using the MonitorLink/DVI input.

�

��

�

��

�

��

�

Table of Contents

Table of Contents