Table of Contents
Advertisement
Connecting an External Digital TV (DTV or HDTV) Receiver with
RGB, HV Video Connections
External Digital TV (DTV or HDTV) Receiver with RGB, HV Video Connections
Figure 13
1. Connect the outside antenna, cable or satellite to ANT or SATELLITE IN on the DTV receiver (see your DTV receiver
owner's guide for instructions and cable compatibility).
2. Connect the incoming terrestrial antenna or cable (not satellite) to ANT-A on the TV back panel (a coaxial splitter,
available at most electronic supply stores, may be required to complete this installation).
3. Connect RGB cables from the DTV receiver to Input-DTV on the TV back panel.
Note: You may need to set the Input-DTV assignment to RGB instead of YPrPb. Refer to the Edit NetCommand®
Setup in book 2 for instructions on changing this setting.
DTV Receiver to TV Back Panel
• G (green) to Y/G
• R (red) to Pr/R
• B (blue) to Pb/B
4. Connect the H & V sync signals as shown below:
• H (horizontal sync) to H
• V (vertical sync) to V
All 5 cables (G,R,B,H and V) must be connected. 3 cables or Sync on green connections are incomplete and will not work.
5. Connect the L (left) and R (right) audio cables from the DTV receiver to Input-DTV AUDIO on the TV back panel.
�
�
�
�
�
�
�
�
��
��������
�������
�� �����
�
��� �������� ����� ��� ������������
�
�
�
Figure 13. Connecting an External DTV Receiver with RGB Video Connections
34
�
�
�
�
�
���������������������
�
�����
�
���
�
�� ���� ���
��
�
It may be necessary to obtain a VGA to RGB,
HV adaptor cable. These are available at most
computer stores and many electronic stores.
Some of the adaptor cables have RCA type
connector ends, others have BNC type ends
and will require adaptors as shown on page 32.
See Appendix B in book 2 for RGB, HV
video signal compatibility information.
For digital audio connections, see your
DTV Receiver and A/V Receiver Owner's
Guides.
��������� ��
�� ��������
����� �� ���������
�
IMPORTANT
Advertisement
Chapters
Table of Contents
