Setup Menu - Mitsubishi WL-82913 Connections And Maintenance

Setup Menu

Setup Menu
Figure 8
Select Setup to perform the following functions.
Figure 8. Setup Menu, NetCommand Option
Edit NetCommand
Detailed information regarding Edit NetCommand is found
in Chapter 2. The functions of Edit NetCommand are:
• ADD - Addition of new devices.
• CHANGE - Change or edit traditional devices and IEEE
1394 devices.
• DELETE - Delete a single device or delete the entire setup
configuration. After deleting, you will be able to start with
the Initial NetCommand screen.
• REVIEW - Review all devices connected to the TV,
including IEEE 1394 devices, and turn devices and unused
inputs On or Off.
• INITIAL - Allows initial setup, in the event NetCommand
setup was cancelled or if the entire configuration was
deleted or not completed.
Icon Position
Selecting the Icon Position screen allows you to arrange
the device icon order on the Device Selection menu to
your preferred sequence to make the operation of the TV
easier.
Press ADJUST , , or
moved and then press ENT(er). Press ADJUST
or to move the icon to the desired position and then
press ENT(er) to secure the icon in the new position.
®
to highlight the icon to be
,
Transport Menu
The Transport Menu is used by NetCommand® to control
VCRs, DVDs, IEEE 1394 AV Disc, digital VCRs, and similar
devices. This menu can be turned off if you would rather
not have it displayed. The transport buttons on the
remote control will continue to operate these devices.
See page 37 for more detailed information regarding this
feature.
Energy Mode
This feature allows you to save electrical energy when the
TV is off and in the standby mode. Standard mode uses
more power but allows all of the background features to
continue to operate. Low mode saves power (using less
than 3 watts), however, using this selection will restrict or
turn off many of the background features.
If the Energy Mode is set to Low the following features
of the TV will be restricted or unavailable when the TV is
turned off (Note: The features will operate normally when
the TV is powered On).
• TV controlled recordings, including "Record Later "
recordings will not be possible.
• TV Time (clock) will be lost after approximately 48 hours.
The clock will need to be reset through the Time menu.
• The Timer function cannot be used to turn on the TV.
• IEEE 1394 functions that pass through the TV or IEEE 1394
recordings from the TV or Ant-DTV will not be possible.
• The amount of time required to turn on the TV will increase
to more than one minute.
Language
Display the on-screen menus in either English or Spanish
(Español). The first time you powered On your TV, you
were requested to select an on-screen menu language.
If you choose to change the selection, all menu text will
,
immediately switch to the language of your choice.
43