Stand-Alone Monitor Eq - dbx DriveRack 480 User Manual

DriveRack
Hardware
Note Make sure that all outputs are muted on the DriveRack™ prior to adding power to any
devices in the signal path (pre and post DriveRack™).
Connect the outputs sends from the mixer to the inputs of the DriveRack™.
1.
2. Connect the outputs of the DriveRack™ and run to the returns of the mixer.
4. Connect the optional 480R to the DriveRack™ via the network connector.
5. Making sure that all outputs are muted, apply power to the mixer.
Software
1. From Program/Config mode, select the desired configuration by using the PARAMETER 1
knob to scroll through the Program/Configuration menu. For more information on config-
uration procedures, please see section 3.
2. From Program mode, use either the selected effect editing button or the PARAMETER 2
and 3 knobs to access and edit the desired parameter. For more information on parame-
ters, please see section 4.
3. Press the OTHER button to access the input and output level controls of the unit.
Successive presses of the OTHER button will move you through the four input and eight
outputs of the unit.
®
™
Application Guide
9.6 - Stand Alone Monitor EQ
DriveRack™ User Manual
Section 9
87