Install Driver In Windows Xp / 2000; Installing The Raid Driver (For Bootable Raid Array - MSI P965 Neo User Manual

Installing the RAID Driver (For bootable RAID array)

Install Driver in Windows XP / 2000

† New Windows XP / 2000 Installation
The following details the installation of the drivers while installing W indows XP /
2000.
1. Start the installation:
Boot from the CD-ROM. Press F6 when the message "Press F6 if you
need to install third party SCSI or RAID driver" appears.
2. W hen the W indows XP/2000 Setup window is generated, press <S> key to
specify an Additional Device(s).
3. Insert the driver diskette JMicron RAID Driver For Win2K/XP driver
into drive A: and press <Enter>.
Important
The S ilic on Image J M ic ron RAID Driv er Ins tallation Dis k s hould be
accompanied in the mainboard package. You may make the Serial ATA RAID
driver by yourself by following the instruction below.
1. Insert the MSI CD into the CD-ROM drive.
2. Click the "Browse CD" botton on the Setup Screen.
3. Copy all the contents in the \\IDE \ JM icron \ Floppy to a formatted
floppy disk.
4. The driver disk for JM icron RAID Controller is done.
4. Choose the driver JM icron RAID Controller that appears on W indows
XP/2000 Setup screen, and press the <Enter> key.
5. Press <Enter> to continue with installation or if you need to specify any
additional devices to be installed, do so at this time. Once all devices are
specified, press <Enter> to continue with installation.
6. From the W indows XP/2000 Setup screen, press the <Enter> key. Setup
will now load all device files and then continue the W indows XP/2000
installation.
† Installing OS on RAID Drive
1. After setup examines your disks, it will copy files to W indows installation
folders and restart the system.
2. The setup program will continue and finish the installation after restarting.
3. W ait until W indows XP/2000 finishes installing devices, regional settings,
networking settings, components, and final set of tasks, then reboot the
system if necessary.
† Confirming Windows XP/2000 Driver Installation
1. From W indows XP/2000, open the Control Panel from My Computer
followed by the System icon.
2. Choose the Hardware tab, then click the Device M anager tab.
3. Click the "+" in front of the SCSI and RAID Controllers hardware type.
The driver should appear.
JM icron RAID Introduction
B-9