MSI MS-6380LE User Manual page 70

Auto
Call VGA at S3 Resuming
Selecting Enabled allows BIOS to call VGA BIOS to initialize the VGA card
when system wakes up (resume) from S3 sleep state. The system resume time
is shortened when you disable the function, but system will need an AGP
driver to initialize the VGA card. Therefore, if the AGP driver of the card does
not support the initialization feature, the display may work abnormally or not
function after resuming from S3.
USB Wakeup From S3
This item allows the activity of the USB device to wake up the system from S3
(Suspend to RAM) sleep state. Settings: Enabled, Disabled.
Power Management/APM
Setting to Enabled will activate an Advanced Power Management (APM)
device to enhance Max Saving mode and stop CPU internal clock. Settings:
Disabled, Enabled.
Power/Sleep LED
This item configures how the system uses power LED on the case to indicate
the sleep/suspend state. Available options are:
Single LED The power LED turns off to indicate the sleep/suspend
Dual LED
Suspend Time Out (Minute)
After the selected period of system inactivity, all devices except the CPU shut
off. Settings: Disabled, 1, 2, 4, 8, 10, 20, 30, 40, 50, 60.
Display Activity
These items specify if the BIOS will monitor the activity of the specified hard-
ware peripheral or component. If set to Monitor, any activity detected on the
specified hardware peripheral or component will wake up the system or pre-
vent the system from entering the power saving modes. Settings: Monitor,
Ignore.
The information stored in memory will be used to restore
the system when a "wake up" event occurs.
BIOS determines the best mode automatically.
state.
The power LED changes its color to indicate the sleep/
suspend state.
3-19
BIOS Setup