MSI 925XE Neo Platinum User Manual page 49

Security Option
This specifies the type of BIOS password protection that is implemented. Settings are
described below:
Option Description
[Setup] The password prompt appears only when end users try to run
Setup.
[System] A password prompt appears every time when the computer is
powered on or when end users try to run Setup.
MPS Table Version
This field allows you to select which MPS (Multi-Processor Specification) version to
be used for the operating system. You need to select the MPS version supported by
your operating system. To find out which version to use, consult the vendor of your
operating system. Setting options: [1.4], [1.1].
Boot to OS/2
This allows you to run the OS/2
When you choose [No], you cannot run the OS/2
than 64MB. But it is possible if you choose [Yes]. Setting options: [Yes], [No].
Full Screen LOGO Display
This item enables you to show the company logo on the bootup screen. Settings are:
[Enabled]
[Disabled]
Boot Sequence
Press <Enter> to enter the sub-menu and the following screen appears:
1st/2nd/3rd Boot Device
The items allow you to set the sequence of boot devices where BIOS attempts to load
the disk operating system.
Boot from Other Device
Setting the option to [Enabled] allows the system to try to boot from other device if the
system fails to boot from the 1st/2nd/3rd boot device.
MSI Reminds You...
Available settings for "1st/2nd/3rd Boot Device" vary depending on the
bootable devices you have installed. For example, if you did not install
a floppy drive, the setting "Floppy" will not show up.
® operating system with DRAM larger than 64MB.
Shows a still image (logo) on the full screen at boot.
Shows the POST messages at boot.
®
operating system with DRAM larger
BIOS Setup
3-9