Necessary Settings Before Use; Power Related Preparations (Using The Battery Pack) - JVC GZ-MG57AA Instructions Manual

Necessary Settings before Use

14
EN
Be sure to configure the following three settings
before use.
Power Related Preparations
(Using the Battery Pack)
1
Set the power switch to OFF.
Slide while pressing down the lock button.
Lock button
2
Attach the battery pack.
Slide the battery pack down until it locks in
place.
Bottom of the Camera
Controls in this section
Power Switch
INDEX
Power off
Playback
Recording
BATT.
Power/Charge Lamp
MENU
/ / / / 49
3
Charge the battery pack by
connecting to the AC adapter.
Open the cover.
AC Adapter
(ex. AP-V17E)*
* If the provided AC adapter is AP-V14E,
connect the power cord to the AC adapter,
and plug the power cord into an AC outlet.
The power/charge lamp blinks to indicate
charging has started.
When the lamp goes out, charging is
finished. Unplug the AC adapter (or the
power cord) from the AC outlet and
disconnect the AC adapter from the camera.
To detach the battery pack
Slide and hold BATT. (
the battery pack.
To check the remaining battery power
( pg. 16)
Required charging / recording time
Battery pack Charging time
BN-VF707U
1 hr. 30 min.
(Provided)
BN-VF714U 2 hr. 40 min.
BN-VF733U 5 hr. 40 min.
The times shown above are approximate times.
The values within ( ) are the times when the
LED light is on.
NOTE:
You can also use the camera with just the AC
adapter.
DC
Connector
To AC Outlet
(110V to 240V)
step 2), then remove
Recording
time
1 hr. 10 min.
(1 hr. 5 min.)
2 hr. 25 min.
(2 hr. 20 min.)
5 hr. 50 min.
(5 hr. 30 min.)