Disposal After Washing - Haier HWM65-728 User Manual

7 Disposal after washing

After using, please clean the lint and foreign materials of the lint filter etc. in time. Otherwise it may
Influence your using the machine.
Please first pull off the power plug from the receptacle before cleaning.
Clean the detergent box and set it on
the control panel seat.
1.The method of dismantle: Push it up aslant
and gently.
2.The method of install : install it upwards
and aslant and push it in .
Dismantle
The filter screen of the water inlet valveis
likely to be blocked by foreign materials
and influence the water inlet.Please clean
it with brush every two months.
1.After washing, close the water faucet. ( If needed, you can dismantle the water inlet hose).
2.Do not store water in the washing machine for a long period. Drain the water completely
after each using.
3.Be sure to pull off the power plug before maintenance.
4.Hang up the power cord and drain hose.
5.Wipe off the water drops on the surface of the machine and inside the tub. Open the top
lid for some time (about 1 hour), then close the top lid.
The lint filter must be used during washing.
It must be cleaned in time after each using.
Lint filter:
1.Push down the spring piece of the top lint filter
to make the claws out of the filter cover, and then
pull out the lint filter to get it down. figure1
2.Pull the back of the lint filter, and then you can
get down it off the front cover of the lint filter. figure2
3.Sweep the rubbish in the lint filter.
4.Put the back of the lint filter into the front cover .
5.Put the lint filter into filter cover, and make it tight .
6.Make sure the lint filter well installed, or it can
influence your use.
Install
Install
Figure 1
If the cabinet is dirty, wipe it with wet cloth
Do not flush it directly with water.
Wipe it with neutral detergent.
Do not wipe it with thinner, petrol, alcohol etc.
14
The back cover of lint filter
Up
Dismantle Dismantle
Down
The front cover of lint filter
Down
Figure 2
Up
Install