Related Manuals for Haier HWM65-0523S
Summary of Contents for Haier HWM65-0523S
- Page 1 Twin-tub Washing Machine with Pump User's manual This manual is for HWM60-0523S Please read this manual carefully before using. Retain it for future reference.
-
Page 2: Table Of Contents
Contents Names of the parts Safety precautions Installation and adjustment Preparation before washing The musts in washing Usage of the detergent Washing sequence Disposal after washing Trouble-Shooting *Answers to question Packing list *Specification... -
Page 3: Names Of The Parts
Names of the parts Outer cover of the spin tub Wash selector Inner cover of the spin tub Wash timer Spin timer Water-filling entrance Spin tub frame Control panel Spin tub Overflow filter Water level adjusting lever Cabinet Lint filter(Installed by user) Power cord Pulsator Wash tub... -
Page 4: Safety Precautions
Safety precautions Please insert the power cord into When the machine is normally special receptacle with rated vol- using, please put the power plug tage.Be sure to use single-phase at the location easily to be insert- three pins receptacle.The earthing ed and extracted by hand. - Page 5 Safety precautions Do not stretch hands into the working Do not decompose, repair or alter the machine. It is dangerous even if the machine by yourself. rotation is slow. Take special care of the children. Do not put any hot or heavy items Do not wash laundries with volatile ( such as the kettle with hot water ) materials (such as thinner, petrol etc.).
-
Page 6: Installation And Adjustment
Installation and adjustment Please install and adjust the machine according to the requirement of the manual. It is very important to your security and correct operating the machine. Usage of the drain hose The drainage shall be smooth with the drain hose. 1.The height of the drain hose shall be less than 1.2m , or the drainage will not be smooth enough and cause incomplete drainage. -
Page 7: How To Change The Direction Of The Drain Hoses
How to change the direction of the drain hoses Figure 1 indicates the ex factory installation Back position of the drain hose. Soft item Extend the drain hose from the side of spin tub Front Figure 1 Put soft items on the ground. Lean the machine down gently with the front surface facing the ground. -
Page 8: Preparation Before Washing
Preparation before washing Preparation before washing 1.Connect the water inlet hose. 2.Confirm that the washing machine is earthed reliably . Then insert the power plug into the receptacle. Do not connect the earth terminal to the gas pipe and tap water pipe. Put the drain hose up to suitable position 4.Slanting or uneven ground may result in unstable working or abnormal noise. -
Page 9: The Musts In Washing
The musts in washing The capacity of washing and spinning of the machine refer to the largest weight of the standard laundries under dry condition that can be washed or spinned in one time. Laundries quantity in one washing cycle shall be lower than the rated capacity. -
Page 10: Washing Sequence
Washing sequence Spin timer Wash timer Wash selector (to set to below 1 minute, (To set to below 2 minute, (standard current, first set to 2 minute then first set to 5 minute then strong current) turn it back. it can increase turn it back. - Page 11 Spinning 1.Put the laundries into the spin tub evenly and smoothly. 2.Spin (1) Put the gland in properly. Please put in the gland properly even if the laundries quantity is small. Push Gland Push Proper Proper The laundries No gland are slanting (2) Close the inner and outer cover of the spin tub.
-
Page 12: Disposal After Washing
Disposal after washing After using, please clean the lint and foreign materials of the lint filter and overflow filter in time. Otherwise it may influence your using the machine. Please first pull off the power plug from the receptacle before cleaning. Cleaning the lint filter The lint filter must be used during washing. -
Page 13: Cleaning The Overflow Filter
Cleaning the overflow filter 2. Take off the corrugation pipe. Dismantle the upper part of the Water level adjusting lever corrugation pipe inside overflow filter ( as indicated in Corrugation Figure 1). Pipe 3. Cleaning the overflow filter Clean the lint around the filter and flush with tap water. -
Page 14: Trouble-Shooting Answers To Question
Trouble-shooting Answers to question If the laundries fall to the outer side of the spin tub If the laundries fall to the outer side of the spin tub, Please come to the special maintenance department or after-sale service department of our company. Do not repair it by yourself. When the remained water is frozen Prevent the freezing (be sure to discharge the water completely after using) - Page 15 Trouble-shooting Answers to question (If there's breakdown, please pull off the power plug before checking) The following phenomena are not breakdowns sometimes. Please confirm again before sending it to repair. If there are real breakdowns, please come to the special maintenance department or after-sale service department of our company.
-
Page 16: Packing List
Packing list Quantity Name One piece User's manual One piece Water inlet hose One piece Lint filter One piece Gland One set Twin-tub washing machine Specification Water level/Water quantity (about) Maximum/43L Medium/36L Minimum/30L Injection pressure(MPa) 0.02 0.2 Rated washing capacity(kg) 6.0 (weight of standard dry cloth)