Displaying And Setting Fastboot Mode - HP Vizualize,Visualize b2000 Supplementary Manual

Boot Console Handler

Displaying and Setting Fastboot Mode

Displaying and Setting Fastboot Mode
When fastboot is enabled (set to on), the system does a quick check of the memory and
skips I/O interface testing during its power-on self tests. This enables the system to
complete its boot process quicker. The default factory setting is for fastboot to be enabled
(set to on). Note that fastboot can be set using the Boot Console Handler's Configuration
Menu.
When fastboot is disabled (set to off), more extensive memory testing and I/O interface
testing is performed during the self tests, causing the boot process to take longer.
If you are experiencing difficulty in booting the system, set fastboot to off and reboot the
system. More extensive testing may reveal the error condition.
To display the status of fastboot, type the following at the prompt and press
Configuration Menu: Enter command> fastboot
To disable fastboot, type the following at the prompt and press
Configuration Menu: Enter command> fastboot off
To enable fastboot, type the following at the prompt and press
Configuration Menu: Enter command> fastboot on
160
:
Enter
:
Enter
:
Enter
Chapter 6