Positive Stop - Grizzly EXTREME G0514X2 Owner's Manual

Figure 18. Blade tracking controls.
G0513X/G0514X/G0514X3 Extreme Series Bandsaw

Positive Stop

Personal injury or death
can occur if the bandsaw
starts during table adjust-
ments. Disconnect power
from the bandsaw before
performing table adjust-
ments.
The positive stop allows the table to be quickly
and accurately returned to the horizontal (0˚)
position after being adjusted to a different angle.
Components and Hardware Needed:
Hex Bolt M8-1.25 x 90 ....................................... 1
Hex Nut M8-1.25 ............................................... 1
To install the positive stop:
1. Thread the M8-1.25 hex nut halfway onto
the M8-1.25 x 90 hex bolt (this is the positive
stop bolt).
2.
Thread the positive stop bolt into the thread-
ed hole on bandsaw body as shown in
Figure 19.
Figure 19. Installed positive stop bolt.
Qty
Positive Stop
-23-