Table Tilt; Aligning Table - Grizzly G0456 Owner's Manual

Table Tilt

When the table tilt is set to 0˚, the table should be
adjusted perpendicular to the sanding disc face.
Tools Needed
Try-Square or Machinist's Square ..................... 1
To adjust table tilt:
1.
Using a try-square or machinist's square,
set one edge on the table surface and the
other against the face of the disc as shown in
Figure 51. Note: This can be done with the
sandpaper installed, although it is somewhat
easier to measure if the disc does not have
the sandpaper disc installed.
Figure 51. Squaring table to disc.
2. Loosen the lock lever, adjust the table angle
square with the disc, and tighten the lock
lever.
3. Adjust the indicator line over the 0° mark by
loosening/tightening the mounting screw, as
shown in Figure 52.
Figure 52. Adjusting table tilt indicator.
G0456 Variable Speed Wood Lathe

Aligning Table

The table must be aligned to the face of the
sanding disc so that the sandpaper does not rub
against the table.
Qty
To align the table:
1. Loosen the table mount bolts (Figure 53)
that secure the table to the table support
bracket.
Figure 53. Table mount bolts.
-35-