Table of Contents
Advertisement
Speed Range Improvement
The lathe now has two variable speed ranges.
The new ranges are 300–2000 (Low) and 460–
3000 (High).
Changing Speeds
To change between High and Low speeds:
1.
DISCONNECT LATHE POWER SOURCE!
2.
Remove the front and rear headstock covers
(located just behind the sanding disc).
3.
Loosen the adjustment bolt (Figure 2).
Handle
Low
Lock Bolt
2
Figure
. Belt tension controls.
4.
Use the handle to loosen the belt.
5.
Place the belt on the next pulley step to select
the other speed range.
-2-
Spindle
Pulley
Lock Bolt
High
Motor
Pulley
6.
Use the handle to tension the belt, then
tighten adjustment bolt to keep the belt tight.
7.
Replace the front and rear covers.
Tool Rest Extension
A tool rest extension has been added to the
Model G0456 and you will find this additional part
in the inventory contents when you open the ship-
ping crate.
The tool rest can be installed with or without the
tool rest extension. Figure 3 shows the tool rest
extension installed.
Figure 3. Tool rest extension installed.
G0456 Wood Lathe
Advertisement
Table of Contents
