Gigabyte GA-P35-DQ6 User Manual page 77

C. Configuring a RAID array in RAID BIOS
Enter the RAID BIOS setup utility to configure a RAID array. Skip this step and proceed to the installation
of Windows operating system for a non-RAID configuration.
Step 1:
After the POST memory test begins and before the operating system boot begins, look for a message
which says "Press <Ctrl-I> to enter Configuration Utility" (Figure 2). Press <Ctrl> + <I> to enter the RAID
Configuration Utility.
Intel(R) Matrix Storage Manager option ROM v7.5.0.1014 ICH9R wRAID5
Copyright(C) 2003-07 Intel Corporation. All Rights Reversed.
RAID Volumes :
None defined.
Physical Disks :
Port Drive Model
0 ST3120026AS
1 ST3120026AS
Press <CTRL - I>
Step 2:
After you press <Ctrl> + <I>, the MAIN MENU screen will appear (Figure 3).
Create RAID Volume
If you want to create a RAID array, select Create RAID Volume in MAIN MENU and press <Enter>.
Intel(R) Matrix Storage Manager option ROM v7.5.0.1014 ICH9R wRAID5
1. Create RAID Volume
2. Delete RAID Volume
RAID Volumes :
None defined.
Physical Disks :
Port Drive Model
0 ST3120026AS
1 ST3120026AS
[ ]-Select
Serial #
3JT354CP
3JT329JX
to enter Configuration Utility..
Figure 2
Copyright(C) 2003-07 Intel Corporation. All Rights Reversed.
[ MAIN MENU ]
[ DISK/VOLUME INFORMATION ]
Serial #
3JT354CP
3JT329JX
[ESC]-Exit
Figure 3
- 77 -
Size Type/Status(Vol ID)
111.7GB Non-RAID Disk
111.7GB Non-RAID Disk
3. Reset Disks to Non-RAID
4. Exit
Size Type/Status(Vol ID)
111.7GB Non-RAID Disk
111.7GB Non-RAID Disk
[ENTER]-Select Menu
Appendix