Gigabyte GA-965P-DQ6 User Manual page 86

Step 3:
When Setup correctly recognizes the driver in the floppy disk, a controller menu similar to Figure 20
below will appear. Use the ARROW keys to select one of the items displayed depending on the
operating system to be installed. For example, select GIGABYTE GBB363 RAID Controller (Windows
2K/XP/2003) if you wish to install Windows XP (32-Bit). Then press ENTER.
(Note)
Windows Setup
You have chosen to configure a SCSI Adapter for use with Windows,
using a device support disk provided by an adapter manufacturer.
Select the SCSI Adapter you want from the following list, or press ESC
to return to the previous screen.
GIGABYTE GBB363 RAID Controller (Windows 2K/XP/2003)
GIGABYTE GBB363 AHCI Controller (Windows 2K/XP/2003)
GIGABYTE GBB360 RAID Controller (Windows 2K/XP/2003)
GIGABYTE GBB360 AHCI Controller (Windows 2K/XP/2003)
ENTER=Select F3=Exit
If a message appears saying one or some file(s) cannot be found, please check the floppy disk
or copy the correct SATA driver again from the motherboard driver CD.
Step 4:
When the next screen (Figure 21) appears, press ENTER to continue the SATA driver installation from
the floppy disk.
Windows Setup
Setup will load support for the following mass storage device(s):
GIGABYTE GBB363 RAID Controller (Windows 2K/XP/2003)
* To specify additional SCSI adapters, CD-ROM drives, or special
disk controllers for use with Windows, including those for
which you have a device support disk from a mass storage device
manufacturer, press S.
* If you do not have any device support disks from a mass storage
device manufacturer, or do not want to specify additional
mass storage devices for use with Windows, press ENTER.
S=Specify Additional Device ENTER=Continue F3=Exit
(Note) If you set the Onboard SATA/IDE Ctrl Mode item in BIOS Setup to AHCI mode, please select
GIGABYTE GBB363 AHCI Controller (Windows 2K/XP/2003).
GA-965P-DQ6 Motherboard
Figure 20
Figure 21
- 86 -