Table of Contents
Advertisement
CPU Host Cl ock Control
Note: If sy st e m hangs up before enter CMOS setup utility , w ait for 20 sec for times out reboot. When
time out occur, sy stem w ill reset and run at CPU default Host clock at nex t boot.
Disabled
Disable CPU Host Clock Control.(Default v alue)
Enabled
Enable CPU Host Clock Control.
CPU Host Frequency
100MHz ~ 355MHz
Incorrect using it may cause y our sy stem broken. For pow er End-User use only !
AGP/PCI/S RC Fixed
Serial ATA dev ice is v ery sensitiv e to SRC clock. SRC ov er clock may make Serial ATA dev ice
function can't w ork properly .
Adjust AGP/PCI/SRC clock asy chrohous w ith CPU.
Memory Frequency For
for FSB(Front Side Bus) frequency =400MHz,
2.66
Memory Frequency = Host clock X 2.66.
Auto
Set Memory frequency by DRAM SPD data. (Default v alue)
for FSB(Front Side Bus) frequency =533MHz,
2.0
Memory Frequency = Hos t clock X 2.0
2.5
Memory Frequency = Host clock X 2.5.
Auto
Set Memory frequency by DRAM SPD data. (Default v alue)
for FSB(Front Side Bus) frequency =800MHz,
2.0
Memory Frequency = Host clock X 2.0.
1.6
Memory Frequency = Host clock X 1.6.
1.33
Memory Frequency = Host clock X 1.33.
Auto
Set Memory frequency by DRAM SPD data. (Default v alue)
Memory Frequency(Mhz)
The v alues depend on CPU Host Frequency (Mhz) .
GA-8IPE1000 Pro3 Motherboard
Set CPU Host Clock from 100MHz to 355MHz.
- 56 -
.
Advertisement
Table of Contents
