Table of Contents
Advertisement
2. Select the stripe value for the RAID 0 array by scrolling through the available values by using the Up
and Down arrow keys and pressing the <Enter> key.
3. The available values range from 4KB to 128KB increments. The strip value should be chosen based
on the planned drive usage. Some suggested selections are listed below.
16KB - Best for sequential transfers
64KB - Good general purpose strip size
128KB - Best performance for most desktops and workstations
4. Press the <Enter> key again to the Create Volume prompt to create the array. Confirm this selection
by pressing the <Y> key after the prompt.
5. Scroll to option 4. Exit and press the <Enter> key to exit the RAID configuration utility. Confirm the
exit by pressing <Y> key.
Delete RAID Volume:
Intel (R) Integrated RAID for Serial ATA - RAID Configuration Utility
Copyright (C) 2003 Intel Corporation. All Rights Reserved. V3.x.x.x.xxxx
RAID Volum es:
None defined.
Non-RAID Disks:
Port Drive M odel
0 ST380013AS
1 ST3120023AS
[áâ] - Select
GA-8IPE1000 Pro3 Motherboard
Are you sure you want to create this volume (Y/N)
[ MAIN MENU ]
1. Create RAID Volume
2. Delete RAID Volume
3. Reset Disks to Non-RAID
4. Exit
[ DISK/VOLUME INFORMATION ]
Serial #
Size
3JV22L2J
74.5GB
3KA1ML5V
111.7GB
[ESC] - Exit
- 104 -
Status
Bootable
Normal
Yes
Normal
Yes
[Enter] - Select Menu
Advertisement
Table of Contents
