Gigabyte N521U User Manual page 41

Once your selections have been saved, the Setup program asks you
to confirm your choice, and then reboot the computer.
System will reboot if OK is selected and will stay in Setup if Cancel
is selected.
The next time you boot up the Notebook, the BIOS will attempt to
load the values you saved in Non Volatile memory. If these values
cause the system boot to fail, reboot and press [F2] to enter the
Setup program. Once in Setup, you can try to change the values
that caused the system boot to fail. If the problem persists, load the
default values (see Get Default Values below).
If you attempt to exit the Setup program without saving your chang-
es, the program will prompt you with a message asking if you want to
save your changes before exiting.
Exit (No Save)
This option can be used if you do not want to save the changes you
have made to the Setup program. The default is set to No. If you
have made changes to the fields other than system date, system
time and password, the system will ask for confirmation when choos-
ing Exit (No Save).
The system reboots using the original Setup values.
Default Settings
This option allows you to load the default values for each of the
parameters on the Setup Menus. When this option is selected, a
confirmation message appears.
The system will remain in Setup after either selection.
You can now select Save and Exit or make other changes before
saving the values to Non Volatile RAM.
Restore Settings
Restores the Setup program's values to the ones it had when you
entered the program during the boot sequence.
N521 Series User's Manual
30