Pairing Your Headset To The Base - Jabra GN 6110 User Manual

Battery charge indication
The headset indicator lights to indicate charging, and will turn off when fully charged. The 4 lights of
the battery indicator show the approximate battery charge level of the headset:
• 1 lit indicator represents 25% of a full charge (will fl ash if less than 25%)
• 4 lit indicators represent a full charge.
Charging with the travel charger
The travel charger works universally (90-240 V), letting you charge the headset in any country. You
will need to purchase separately any required electrical outlet plug-in adapters.
To charge with the travel charger, insert the travel charger plug into the electrical outlet and the
cord's plug into headset.
Note: To ensure optimal charging, ensure that the plug of the travel charger is placed correctly into the
headset. The headset indicator lights when the headset is charging.
Battery saving mode
To save power, the headset enters snooze mode after 1 minute of inactivity. This will in no way affect
the normal use of the headset, and it will re-activate itself immediately when used or when a call
is received.

4.6 Pairing your headset to the base

Pairing your headset
In order for your GN 6110 to work correctly, the headset and the base must be paired together. For
your convenience, these two devices in their original product box have been factory-paired.
If this original pairing is lost (by resetting the base, changing your headset or changing your base),
you will have to pair your headset again to the base. Complete the following steps to pair your
headset again to the base:
1. Press and hold down the Multifunction Button on the headset for 5 seconds [A], after which the
headset indicator lights [B].
2. Within 3 seconds, open the headset boom arm.
The headset can now be paired within the next 5
minutes.
3. Press and hold down the Multifunction Button on
the base for 5 seconds, after which the pairing indi-
cator lights. [C]
Note: Ensure that the headset and base are within
1 metre of each other. After 5 seconds, the base
will automatically pair with the headset.
GN6110_contents_EU_13-02-2004.indd 13
A
~ 5 sec
~ 5 sec
C
B
13
16-02-2004, 11:10:53